NIM

Validation

For more information, see Validation.

  1. Go to Configuration > Validation.

  2. Click an object in the Configuration Resources pane to inspect its dependencies.

    The dependencies are displayed in the Uses and Used By panes:

    2021-06-15_14-52-46.png

To systematically validate the dependencies for a set of objects, see Validate object dependencies.

  1. Go to Configuration > Validation.

  2. In the Configuration Resources pane, deselect any objects that you don't want to include in the validation.

    2021-06-15_14-41-39.png
  3. Click Run.

  4. The Validation tab is loaded and the results are displayed in the Validation Results pane.

    There are three result types:

    success.png

    Success: The dependency is valid.

    warning.png

    Warning: The dependency is incomplete, but will not block the operation.

    error.png

    Error: The dependency is incorrectly configured and will block the operation.

    If the validation is successful, all records are marked Success and displayed in green:

    2021-06-15_14-44-04.png
  5. If there are validation errors, their records are marked Error and displayed in red:

    2021-06-15_14-45-40.png
  6. Click an error record to go to the relevant object's configuration page, where the error can be fixed.

  7. Repeat steps (3) - (6) until all errors are resolved.

To inspect object dependencies on a one-off basis, see Inspect object dependencies.